- New 1.6L GTX Engine from a 1992 323
- 90 GT Upgrade
- Upgrades
- chance to get bigger INTAKE valves...
- Anybody use Genie headers?
- transmission fluid
- how can the engine work w/o flow meter?
- miata ecu?
- Throttle Q?
- Clutch job ? - PLEASE reply ASAP
- What do you guys suggest i buy next??
- Fuel pressure regulator
- K&N Filter
- Apexi S-AFC
- My Protege Shakes!!!
- How Much
- Exedy clutches
- Intake? good/bad?
- What kinda mufflers/exhausts is everyone running?
- Can water get into those custom intakes under the hood?
- slow 94, need to go faster
- how much hoursepower do u people haw in your first gens
- What Tranny Other Than Stock Would Fit My 91 323?
- touchy throttle
- pressure plate for 1st gen
- Vortech?
- Replacing the radiator
- help on tranny
- Engine Help
- Premium fuel with igniton mod?????
- Water pump for DOHC?
- pls.pls.help intake probs.
- quick rpm's question 92 DX 5 speed
- Dyno Results 3/1/02
- Mods For a 1.8l sohc
- mx3 headers?
- Short Throw Shifter
- Fuel Filter question...
- Spark Plugs
- pre-ignition
- what car use a computer code bp01?
- Help with engine code "G" signal ?
- Protege gearing
- bp06 ecu!!!
- Looking for a header ????
- what is an frp
- Ecu
- 90 degree intake tube
- Fidanza flywheel...clutch??
- A dohc 90'protegé computer will fit on my car?
- Free flow cat install cost?!?!?!
- Engine codes
- 1.8L dohc head price
- 1.8L sohc to 1.8L dohc or gtx/gtr
- a rx7 flow meter will fit to my 1.8 sohc
- I Can Use A Msd 6t Ignition In My Protege
- vacuum trick
- somebody know trick for my 1.8 sohc?
- Headers(Racing Beat?...)
- 323 GT BP 1.8 Dyno Numbers
- 323 GT BP 1.8 Dyno Numbers
- GT-R intake manifold
- some new questions
- HKS intake filter!
- Kia Engine
- Bosal~!
- How easy is a tranny swap?!?
- Swapable??
- what engine???
- inlet sizes
- changing the clutch
- 1.3 liter SOHC
- Haltech
- Clutch question....
- Muffler questions
- Ignition Timing.....1st Gen
- Tranny Question
- Direct Hits??????
- MSD ignition rev limiter
- Performance clutch SOHC
- What do you do with the sensor
- KL-ZE conversion?
- Miata engine in protege...
- DOes anyone have the bored throttle body
- Crank seal
- $500 for a control unit????????
- compass motorsports CAI???????
- Pro Car Parts Intake! Does It Fit?????????
- FF to 4WD?
- protoge engine into 323?
- My Dyno chart
- DOHC head on SOHC work?
- Lightened Flywheel
- Jet Ecu Upgrade
- exhaust mod for 1.6L sohc?
- cold air intake (1st gen)
- Miata tranny in Protege?
- RX7 VAF on sohc????
- Unorthodox pulleys???
- Ignition systems
- Venom 400 control module
- V6 into protege swap... gimme some info...
- SOHC to DOHC Swaps
- Engine and Tranny swapping
- performance parts?
- V6 engine
- Which Denso????
- Custom 1.8L Header (1st Gen)
- Spark Plugs??????
- Intake adapters 12.99!!!!!!!
- air filter dapter!!!!!
- forged parts for proteges
- Need some specs, please help
- Engine Swap (1st Gen)
- Engine Swaps!
- about to install protege engine in my 323
- exhaust questions and motor sounds... (1st Gen)
- rev limiter
- throttle response... (1st Gen)
- First Gen Headers
- Dyno Runs