Awesome...subscribing.

Yeah, me too. I'm over in Clearwater, I definitely want to see this install if at all possible!

once i get the parts I'll be happy to show it off....pass the peas you going to the florida mazdapalooza in july?? it's gonna be at fort desoto park....

first part in...pretty important one too

not too bad...any more angles??

It looks like it has an EGT sensor right on the exhaust? or is that an o2?? seems awefully close to the turbine to be an o2.

Are you going to have it rebuilt? Might be worth it...you dont want a fin breaking off and being shot into your engine.

I can get more angles....honestly I probably wont have it rebuilt....it was VERY low mileage(like 6000 miles), and there is ZERO shaft play on it.....yes that's an 02 sensor, I wont be using that part though, the hiboost downpipe will replace it....

the only thing that pissed me off is 2 of the studs on the exhaust housing are broken off so I'll have to "EZ OUT" them and get new ones....

yikes...i hate broken studs on stuff like that...the heat practically wleds them in there.

other angles..DSM downpipe removed

mailman just knocked again...no damn alignment tool though !!!

man, I hope that clutch holds....it looks kinda "budget". The PP kinda looks used also. I'm gonna hate it if you put everything together and get up on it one time and break it.

clutch is an Exedy stage 2...supposed to hold up to 90% over stock, so that should be good for 200lb-ft of torque....pressure plate is def brand new

oh ok..maybe it's just the picture.

First I've heard of it, I checked the info thread on the other forum. The event coincides with the first day of my summer vacation, so I'd say it's highly likely I will go.

I'm will definitely have my install complete and running by then...

Looks good, seems like this project is coming together excellently! Good luck with everything!