vibrantvivid

please help i was cleaning out my closet yesterday and found a set of alpine 6.5"! dopeness. i figured id throw them in the rear but i want to know how to get the fuggen door panel off on them. im just doing the rear for now and ill replace the fronts next week probably. is there any where i can find pictures of a diagram? thanks

Shawn

there is a site that explains in depth how to do this. I cannot remember the URL though. Do some searching through past threads and you'll find it for sure.

Sweedenhouse

Well its kinda a pain in the ***. You gotta pull up, and slide the top part of the door bar back. It feel like you'll be pulling too hard on it, like its gonna break, but it won't. You can even use a flathead screwdriver to carefully shimmy up in there to pry up and see how the bar is connected together. Once you get the door bar split, its pretty self explanatory. I had to figure it out when I put my MB Quart components in. It does suck, but its not as hard as it seems, just be careful and don't trash your panel, while it is pretty tough, it doesn't mean you can just go G.I. Joe apeshit on it.

sunbyrne

Funny, I just did this the other day. Web page is in progress, but probably has most of what you want:

http://byrneweb.com/sunburn/newcar/install.html

That help?

vibrantvivid

fuggin dope homie! i was more than half way there than this morning. thanks for the help

sunbyrne

No problem at all. Hope your install goes smoothly.