Exterior/Interior/Audio Discussion for Exterior/Interior Modifications. Sound systems, body kits, etc.

Protege 5 Trim Q

Thread Tools
 
Search this Thread
 
Old August-10th-2002, 10:43 PM
  #1  
Protege Newbie
Thread Starter
 
SpyGuy's Avatar
 
Join Date: Aug 2002
Location: Saskatchewan, Canada
Posts: 38
SpyGuy is on a distinguished road
Question Protege 5 Trim Q

I haven't tried yet, but how do you remove the Silver trim around the HU. Do you have to remove the heater control ***** or what else is involved???
SpyGuy is offline  
Old August-10th-2002, 10:48 PM
  #2  
I Can Be Teh W1N!!!!
 
pr5owner's Avatar
 
Join Date: Jul 2002
Location: Calgary
Posts: 1,870
pr5owner is on a distinguished road
Re: Protege 5 Trim Q

Originally posted by SpyGuy
I haven't tried yet, but how do you remove the Silver trim around the HU. Do you have to remove the heater control ***** or what else is involved???
no you don't but there are 2 wires that are attached to the heater controls that you have to disconnect, the trim is just held in by clips that you just pop out, i had to replace my trim since it was all scratched up from when the time my car was broken into
________
FORD HSC ENGINE SPECIFICATIONS

Last edited by pr5owner; March-10th-2011 at 09:32 AM.
pr5owner is offline  
Old August-10th-2002, 10:59 PM
  #3  
Protege Newbie
Thread Starter
 
SpyGuy's Avatar
 
Join Date: Aug 2002
Location: Saskatchewan, Canada
Posts: 38
SpyGuy is on a distinguished road
Thanks a lot, so when I disconnect the two wires the whole trim piece will come right out of the way???
SpyGuy is offline  
Old August-10th-2002, 11:10 PM
  #4  
Protege Newbie
 
PR5Monkey's Avatar
 
Join Date: Jul 2002
Location: Atlanta
Posts: 14
PR5Monkey is on a distinguished road
Watch out for two other cables....

Heater/AC Control and Air Outlet Control. These cables are attached via clips. Follow the cables. It has a black housing. If you pull the trim pieces far enough the cable will get dis-lodged from the clip. Slide the cables off the clips before yanking on the trim pieces. After doing cable work to install my amp....

(1) I had no AC. Just heat. The controls did not line up.
(2) It was not blowing air where it was suppose too. Again the controls did not line up.

It tooke an hour and a half to figure it out. Also, Pry the trim from the top first, then down. Use your fingers so you won't mess up the plastic around it. It pops right off.

Have fun,
Jason
PR5Monkey is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
macdaddyslomo
3rd gen Engine/Drivetrain
10
January-3rd-2006 11:40 AM
MarkSpark
Off-Topic
4
March-17th-2003 05:36 PM
jeremy
1st Gen Protege/323/GLC
3
November-4th-2002 11:32 PM
Alpine
Exterior/Interior/Audio
1
September-4th-2002 07:18 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 


Quick Reply: Protege 5 Trim Q



All times are GMT -5. The time now is 09:20 AM.