FCD installed, dynoed again...
#1
FCD installed, dynoed again...
air/fuel did lean out some finally, but after 3600 it never went over 11.4:1. it only sunk below 10:1 at one small point.
10.5 PSI (up from 9.25 the other dyno time) of boost. we did it on the fly after hours and i set the boost level.
197.4 whp, 204.3 tq. for only roughly a pound and a half of boost, thats prettygood. i think that the FCD leaning it out some helped too.
i think a haltech will be in order soon, but adding another 0.5 PSI and busting 200 on pump gas will be fun. we heard no detonation, the A/F was great. i am tempted to drop in a gallon of toluene and see if 13 PSI is reachable. thank god for dynos!
10.5 PSI (up from 9.25 the other dyno time) of boost. we did it on the fly after hours and i set the boost level.
197.4 whp, 204.3 tq. for only roughly a pound and a half of boost, thats prettygood. i think that the FCD leaning it out some helped too.
i think a haltech will be in order soon, but adding another 0.5 PSI and busting 200 on pump gas will be fun. we heard no detonation, the A/F was great. i am tempted to drop in a gallon of toluene and see if 13 PSI is reachable. thank god for dynos!
Thread
Thread Starter
Forum
Replies
Last Post
DonSVO
3rd Gen Protege/MazdaSpeed/P5/MP3
22
October-10th-2004 12:03 PM
protejay
1st gen/323/GLC Engine and Drivetrain
2
January-1st-2003 09:32 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)