Just use a cold air intake from a 94-97 acura integra. I just installed it on my car today and damn at the sound and performance. You don't even have to move the battery and it doesn't have that damn 90 degree angle of the ones for our cars.
All you have to do is take out all of the factory filter box components even the part behind the drivers fender, unhook the mass air sensor tube from the filter box , you'll need this. The pipe comes as one piece , all you have to do is cut it into two pieces but make sure you cut it so that the sensor plug will reach the mass sensor. You'll just have to pick up 2 more intake couplers w/ 2 1/2 " inlet they sell these at autozone for 4.99. I installed mine and turned bottom half of the filter tube to where it runs right into the drivers fender hole where the other filter tube used to run, and thats it, damn the engine will scream, Enjoy if you have any futher questions on this install email me at protegeracer2f2f@aol.com

 

Hey, sounds nice. but can u post some picts up for me.
Or maybe send me some.. Also, how much did it cost u for that intake??

 

I'm not pretty sure if the acura integra CAI would be very good. I mean it may sound better but to my understanding.. Don't most honda intakes run around 2 inch piping? The difference in pipping may defintely make you lose power. So I guess you would just have to fool around and see if it works or not.