sounds great!! hopefully by this time next month we'll all be enjoying them

 

no no no, it won't take that long!! Nick said he estimated 2 weeks to your door.....1 week to finisdh them all and another for shipping...anticipating for any delays he added another week just to be safe.

 

ya, i was leaving some time for installation i may or may not be able to put it on right away (pending my work schedule and being on call)

 

word of advice to everyone...

WD40 IS YOUR BEST FRIEND!!!

rusted out threads pwn3d me....I ended up tearing every thread off 3 out of 5 of the bolts.....was not pleasant.

 

Do we have to tighten this to a specific torque spec? or can we just tighten them up real tight?

 

nah, just snug it up good, crank the car and while it's running QUICKLY check for leaks....you dont want the car getting hot again if you have to get back on the manifold.

 

Should we go by the service manual torque specs? Typically, specs are per fastener size/material, but should we have to change it for SST (vs. C.I)?

I have the Factory Service Manual at home..I'll check the spec.

 

Should we go by the service manual torque specs? Typically, specs are per fastener size/material, but should we have to change it for SST (vs. C.I)?

I have the Factory Service Manual at home..I'll check the spec.

 

Any word on the order(s)? Leading up on two weeks almost (I know, I know...I'm ansty though)

(Please......feed.....addiction.....)

 

dimitrios: you're not the only one.. i was dying for 2 weeks to get here just so i could post and ask for an update

 

I just got back from Wagners' open house. He's still working on the pieces. The laser cut flanges that seal the bottom of the runners and keep the gas in the cat have a center section that Andy has to re-weld into the header. The shop that laser cut the flanges threw those center sections away and set him back a little.

The open house was amazing. I can't say how much nice stuff he has up there....here's a sampling:

2002 PRotege 5 twin turbo (est. 400hp)
2003 MAzda 6 S twin turbo (est. 700hp)
2004 Evo 8 wagner turbo kit (550whp)
2004 Evo 8 RS (brand new)

 

I want in!!

 

No head(er) for you!

 

natey dragged me into this GB then he backs out

hey, i don't mind.. i'm getting a header now and he's not

 

I can't wait till this bad boy comes in!! so when should we expect them around like May 18th-22th? later or earlier? I also have another question matty how much is this piece the wanger hi-flow pre-cat N/A down pipe and will it bolt-on to the wanger header as well? Thanks