Speedo needle stuck after reset
#1
Speedo needle stuck after reset
Hi there,
My tach needle hot stuck. I followed a reset procedure online by pressing the odometer button and turn the ignition on acc / on but not on start then release it. The tach issue was solved but now my speedometer needle is stuck on below zero and will not move at all when I drive. Please advise if you have a solution to that. I tried the resetting procedure again but it did not resolve the issue, Thanks. I have Mazda 3 2009.
My tach needle hot stuck. I followed a reset procedure online by pressing the odometer button and turn the ignition on acc / on but not on start then release it. The tach issue was solved but now my speedometer needle is stuck on below zero and will not move at all when I drive. Please advise if you have a solution to that. I tried the resetting procedure again but it did not resolve the issue, Thanks. I have Mazda 3 2009.
Thread
Thread Starter
Forum
Replies
Last Post
ImportCarPartsPlus
Vendor Section
4
December-12th-2008 05:18 PM
Quantam_Mechanics
Exterior/Interior/Audio
0
June-6th-2008 06:53 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)