I have my neons wired right now...but the switch that I got has positive, negative, and an accessory input on the back. How exactly do I wrie my neons in to the switch, they are currently run to my parking lights.

Thanks,
Adam
99 LX

 

Somebody correct me if I'm wrong, but the ACC is where the power source (IE battery) comes in. The + is sent out to the neons. The - (ground) needs to be grounded, meaning connect it to a metal body point somewhere nearby.

 

almost....

positive = 12v from the battery (either constant or switched when Key is on) make sure it's fused (10amp)

ACC = out to your neon lights (+) wire

ground = to chassis ground (along with the ground wire from the neon(s).

 

my set up is a little different. i have 1 wire from the transformer going to the neon on the driver side then a wire from that to the back neon, to the passenger side to the front and them from the front a wire goes back to the transformer, so its a circle. the transformer is bolted to the frame (ground). then i have a red wire fused wire going inside the car where its attached to 1 lead of the switch and wire from the other lead of this switch is going to the fuse box under the steering wheel.


btw, can somebody help me install a wireless relay to my neons. it allows me to turn the neons on with a remote, like keyless entry. what do i need to do? do i disconect the switch from my red fused wire and use the end of the wire to connect to one of the leads from the relay, then connect relay to power and ground?