2nd gen grille
#1
2nd gen grille
Is there any other grille out there that will
fit the 96' Pro other than the one that comes
stock? I kinda like how the 200sx's look.
Would any of you think that maybe one from it
would fit? I know I would have to shave the emblem.
That's no problem.
Thanks
fit the 96' Pro other than the one that comes
stock? I kinda like how the 200sx's look.
Would any of you think that maybe one from it
would fit? I know I would have to shave the emblem.
That's no problem.
Thanks
#5
you could cut the grills but leave the topmost two...then put filler between them...check out my ride http://www.pbase.com/caloyski5/caloys_ride_updated
#7
no need really to go out there looking for a new grill that could run you 30-50 bucks. just cut the grills in the middle and leave a piece or 2 on the top, spend about 5 bucks at home depot for some mesh and there you go, thats what i did at least. check it out.
http://www.cardomain.com/id/stylinhawyn
http://www.cardomain.com/id/stylinhawyn
#8
Guest
Posts: n/a
With a good dremel, or a small hand saw you can either cut out all the spacers in the gril or you can do a few and mount the grill in. I just chose to do my grill as shown below in the pic, mainly to match the jspec bumper that I have. I am currently planning to install mesh behind the main opening in the bumper and the fog light opening. Ofcourse this is to disguise the intercooler ... lol
Bruce
[IMG]http://www.members.tripod.com/
protosportracing/myjspcimages/
resize/protege1.jpg[/IMG]
Bruce
[IMG]http://www.members.tripod.com/
protosportracing/myjspcimages/
resize/protege1.jpg[/IMG]
Thread
Thread Starter
Forum
Replies
Last Post
92protuner
1st gen/323/GLC Engine and Drivetrain
4
December-1st-2004 11:54 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)