Air/Fuel Gauge hookup?
#1
Air/Fuel Gauge hookup?
Last edited by pr5owner; March-10th-2011 at 09:34 AM.
#3
they are easy to hook up. you'll just need to figure out which of the wires on your o2 sensor is the actual sensor wire. 2 of the wires will be grounds (-), one will be very low voltage ( <1 volt, it will be your sensor wire) and one will be higer voltage which is the sensor heater wire.
the guage just needs a switched 12v (+) and (-) and the sensor wire.
what mods are you doing that you need to monitor your unadjustable a/f ratio? nitrous? turbo?
the guage just needs a switched 12v (+) and (-) and the sensor wire.
what mods are you doing that you need to monitor your unadjustable a/f ratio? nitrous? turbo?
#4
right now just for looks (to go with steering column gauge pod), maybe later a turbo, since their are no kits and everything must be custom fab. i gotta wait
is the O2 sensor located on the heat shield right behind the RAD?
there is a "no touch" sign on the sheild and to the right there is a sensor, is that the one im looking for?
________
Volcano vaporizer
is the O2 sensor located on the heat shield right behind the RAD?
there is a "no touch" sign on the sheild and to the right there is a sensor, is that the one im looking for?
________
Volcano vaporizer
Last edited by pr5owner; March-10th-2011 at 09:35 AM.
#6
yeah i noticed 2, 1 closer to the valve cover 1 at the bottom of the car.. hmm... anyone install one of these before?
________
FORD CVH ENGINE SPECIFICATIONS
________
FORD CVH ENGINE SPECIFICATIONS
Last edited by pr5owner; March-10th-2011 at 09:35 AM.
#7
You want to tap into the one on the upper manifold. The black wires are both grounds. Ask CH design which of the others is the heater or signal. It should be in one of his posts about O2 sensors here somewhere.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)