Intake Fabrication
#1
Intake Fabrication
Ok. I've got the cone filter and the adapter on my pro. I'm wanting to fabricate my own intake. I have a 2.5 in. 180 degree mandrel bent peice of tubing. I have hose clamps that i could clamp it together with. The problem is, I'm not sure how to cut the pipe so it will fit on a SOHC 1st gen. pro. I've looked at several possibilities, but im afraid to just start cutting away and ruin the pipe. Then i would have no intake and no pipe. Any help would be very much appreciated.
#3
Use the original rubber piping as a guide like it shows here.
http://www.teamdelsol.com/home/frameset.htm
http://www.teamdelsol.com/home/frameset.htm
Thread
Thread Starter
Forum
Replies
Last Post
nightflash
1st Gen Protege/323/GLC
5
July-11th-2004 09:58 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)