how hard would it be to put miata seats in a 2nd gen?

 

very

 

What about a set from an MX3??

 

still a PITA

 

****, I was at a junk yard a while back and there must've been a half dozen MX3s in there with complete interiors.
Sounds like a task that I would be capable of doing.

 

mx-3 seats are easy, i did it in less than two hours, the width is the same but the distance front to back of the bolt patterns is a little longer so i had to drill holes in the rear part of the seat bottoms to match up, plus i had to put 1" or 1.5" spacers on the inner side to correct a lean, but the seats look good and feel great. miata can't be that much harder, i kinda thought about those too but the mx3 were easier to get for me

 

man i have yet to see your pics!!!! post them.