APEXi Turbo Timer
#2
apexi timer
k-
first off... forget the ECU connection considering it won't be an accurate reading. secondly, their is no harness that i could find to connect the turbo timer to the ignition. what i did was hunt down the correct connections with a voltometer. after hard wiring i soddered all connections and taped off the O2 sensor i chose not to use. the timer works just fine and i think it looks hot right above the shifter. one thing i learned is that it is better to give the car a little gas before pulling the key. taking your key out of the ignition at a low idle will (for me) sometimes be too quick for the timer to kick on. as a result the engine WILL turn off and the timer will still count down but only running the electricles.
hope this helps
Uncle
first off... forget the ECU connection considering it won't be an accurate reading. secondly, their is no harness that i could find to connect the turbo timer to the ignition. what i did was hunt down the correct connections with a voltometer. after hard wiring i soddered all connections and taped off the O2 sensor i chose not to use. the timer works just fine and i think it looks hot right above the shifter. one thing i learned is that it is better to give the car a little gas before pulling the key. taking your key out of the ignition at a low idle will (for me) sometimes be too quick for the timer to kick on. as a result the engine WILL turn off and the timer will still count down but only running the electricles.
hope this helps
Uncle
Thread
Thread Starter
Forum
Replies
Last Post
2003, apex, apexi, connect, diagram, install, installation, instructions, mazda3, mazdaspeed, protege, timer, tt, turbo, wiring
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)