intake manifold...
The man behind the mask
Joined: Oct 2003
Posts: 11,572
From: Birmingham, AL
not right now. I hear a member is working on one but it's not been proven yet. I'd suggest finding a spare and sending it off to Extrude Hone and getting stage 2 polishing with gasket matching. I believe it would run about $465+shipping. I'd also at this time remove the VCTS system and plug it up.
If I had to guess I'd say you'd get about 10-15whp from this.....the gains would be huge if a head was done at the same time..I've priced this for the pair and it's right at $1000. worth it in my book.
If I had to guess I'd say you'd get about 10-15whp from this.....the gains would be huge if a head was done at the same time..I've priced this for the pair and it's right at $1000. worth it in my book.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
