Installing RB exhaust
February-4th-2003, 03:27 PM
#1
Protege Enthusiast
Thread Starter
Join Date: Jan 2003
Location: Blacksburg, VA
Posts: 57
Installing RB exhaust
ok, I 've read a lot of people say that they've installed there Racing Beat exhaust in a short time. How hard is it to do yourself. Will I need to order anything else to help install it or do I just need a wrench. I would prefer to do it myself and I'm just looking for a little insight as to how hard this project would be. Thanks for any help you can give.
February-5th-2003, 07:53 PM
#3
Protege Enthusiast
Join Date: Jan 2003
Location: Houston,TX
Posts: 100
its not hard, it took me and my friend approximately 30 minutes. Its all just bolt on, no special tools needed. No welding either. Its cake if you you have jack stands and car ramps. Have fun, its a real treat to install stuff yourself and to tell people Yeah I installed that!
February-6th-2003, 01:46 AM
#4
Tree huggin Hippie!!!!!
Join Date: Jun 2002
Location: Brunswick, Maine
Posts: 348
Its not hard. Two bolts that hold it to the flange of the middle pipe, and two rubber hangers. I would spray some WD-40 on the hangers to get them to slide out. Then lower it. Then install the new one. Put the hangers in first the run your bolts.
Thread
Thread Starter
Forum
Replies
Last Post
mota mazda
3rd gen Engine/Drivetrain
2
June-26th-2006 12:43 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)