Vormav

alright guys heres my deliemma(sp?).

say im sitting at a light and i rev it a couple times liek a typical honda boy would.. not revvin the **** outa it.. just to 4500 rpm or so..if that , when my revs come down to about where they should be at idle.. the car will sputter a little an stall , i got a few ideas as to what it may be but i thought id save myuself from tryign al lthem an ask you guys
1)fuel filter 2)fuel pump 3)idle speed

thx in advance

semtex

its always wise to spend the 12 bucks on a fuel filter, it just saves so many headaches down the road, just an FYI

vtec-this

pull your plugs and check to see if there is anything on em. Re-gap them and you should be good. If not, check the timing with a timing gun and that your air filter is clean

Vormav

i already pulled the plugs an cleaned em of any g unk there was on them.. havent checked the air filter or timing yet however..

BadAzz92DX

does it do this at plain old idling too, or just when u rev it first, if it does it at normal idle, check for airflow through the meter and all your hoses

Loginology

Does it sputter when it's idling if you DON'T rev it?

Loginology

I had the same problem because of running rich...never figured it out, I just took the engine out and put the BPT in

Vormav

it does it some time when its at the idle.. but most the time if i rev it

Loginology

You also may want to check your air fitler, and the connection to the air flow sensor.

Vormav

howd you tell what engine code you had?. you do it yerself?

semtex

ok ive heard of that, how and what do you do to get your engine codes, is there a link to it somewhere i cant find it

Vormav

yes enlighten us please

ali Vegas

i think its pin 10 and ground, just short them. then turn the key to the point before starting.

the engine light will flash a number of times. count the number of flashes and thats the code.