Afternoon,

Was looking to get advice on LED badge. I looked thru the forum and see that others have placed an LED badge on the back of their car, and looking to get some advice.

The LED badge is straight and flat, unfortunately the back of the 2009 Mazda 3 Hatchback isn't, there is a curve right down the middle of the trunk lid where the badge goes.

I took it to several places all suggested 3M tape, but that hasn't worked, nor has Emblem glue from Auto Zone. I'm afraid it I try and bend it myself it will break, I asked about heat gun, and was told that would mess up the badge completely.

Has anyone else tried this and do y'all have pictures?

Thanks for the help!

av8