Exhaust, rear section, for 3rd generation mazda protege.. 2"
to 2.25" to 2.5" tubing .. "top one" straight through "bomb style"
exhaust with 4" tip.. should be basically bolt on to any 3rd
generation protege
(except protege 5), muffler itself is 304 stainless steel.. the other
parts are mild steel.. this was custom welded at an exhaust shop and
should last at least 3-4 more years.. it is LOUD! not for the timid
at all.. but it's alot better to buy mine then screwing up your stock
rear-section if you had a similar idea in mind..

this exhaust MIGHT need a custom hanger made depending on your 3rd
gen car, but the tubing is all made and it will bolt to stock tubing
so if you ever have to sell your car you can go back to your old
stock system in under 5 minutes with a wrench.

this exhaust setup does include a silencer, nuts + bolts for silencer
are not included though for the silencer. with the silencer in the
car can pretty close to stock volumes when going on a long distance
trip.. the exhaust is in used but in decent condition (its been on my
car since september of 2001)

http://www.motion-science.com/tradr_/rse.jpg

picture of exhaust on my floor.. off the car.. again this should be
bolt on to any 3rd gen (minus pro5 + mp3 for obvious reasons)

$90 + shipping costs.. I NEED THIS GONE NOW! You can't get this for
less!

email me if you're interested in this at tradr@mailcity.com


I am in Danbury, Connecticut if you want to meet me to buy the parts.

I accept paypal, cashier's check, and M.O., I'm a seller on ebay and
also have feedback there tradr@mailcity.com