I have one question... When installing a front strut bar do I simply take off all the bolts and then place the strut bar in place then tighten the bolts back down? Or do I need that lock tite stuff when putting the bolts back on, because I've read in magazines and seen pictures of them using that stuff before tightening everything back in place?

 

When I installed my, all I did was just taken off the bolts, put it on, and tighten it back up. I've had it on for over a year now, and it hasn't come lose. You certainley could use lock-tight, but I didn't bother.

 

I'll still go buy some lock tite but thank you very much, this means i'll have my front strut bar on this morning, finally.....now only if i could find me some front and rear lower tie bars.