Mazda3/Mazdaspeed3 General/Maintenance Discussion of the Mazda3 and MazdaSpeed3

engine light AND AT light

Thread Tools
 
Search this Thread
 
Old May-14th-2010, 03:06 PM
  #16  
Registered User
 
Maz94Protege's Avatar
 
Join Date: Dec 2001
Location: Northern VA
Posts: 1,016
Maz94Protege is on a distinguished road
Sucks bro. I think the manuals say every 30K change the trans fluid. Atleast that when i change mine in my vehicles. Shop around for the best price for the tranny, if you have the room and good setting and tools id try replacing it yourself to save the money.
Maz94Protege is offline  
Old May-17th-2010, 07:23 PM
  #17  
Registered User
 
kdandrea's Avatar
 
Join Date: May 2010
Posts: 2
kdandrea is an unknown quantity at this point
Originally Posted by Alfa101
Mine generally does not happen under load. Generally at slower speeds around town. It sticks in 3rd. and will neither change up nor down automatically, will not downshift by depressing pedal, and will not work in Manual mode. Only remedy is to come to a complete stop and immediately take off again.
Yeah, this is exactly what is going on with mine.

It will typically clear when I get to a stop light, put it in park and then back into Drive.

It also coincides with my check engine light going on. That will go out if I take the car out a few times without the AT problem.

I bought mine used with about 45K on it....so who knows what maintenance was done on it.
kdandrea is offline  
Old May-19th-2010, 05:57 AM
  #18  
Registered User
 
Maz94Protege's Avatar
 
Join Date: Dec 2001
Location: Northern VA
Posts: 1,016
Maz94Protege is on a distinguished road
im begining to hear that most of these problems are occuring because of prior owners. I know times are tough, but people are not taking care of their vehicles like they used to in the past. And then we are trying to buy a used over a new to save some cash, and were falling into a money pit.

Sorry to hear about the issues guys and gals, but maybe after this small hiccup you all will enjoy the cars and not have any further/major issues.
Maz94Protege is offline  
Old May-20th-2010, 04:58 AM
  #19  
Registered User
 
djs2571's Avatar
 
Join Date: Mar 2007
Location: Newark,ny
Posts: 913
djs2571 is on a distinguished road
When is this 'past' where people took care of their vehicles? I don't think the general motor vehicle user has a clue about what is going on, and will wait thinking any problem is something minor unless the car leaves them stranded.
djs2571 is offline  
Old December-21st-2015, 03:01 PM
  #20  
Registered User
 
Mdutton81's Avatar
 
Join Date: Dec 2015
Posts: 1
Mdutton81 is an unknown quantity at this point
AT light comes on at start, stuck in 4th

Hello everyone,
I have an 04 Mazda 3, 2.3
Car has been very good until here recently. If I go to even start my car, AT light automatically comes on and says its in 4th gear. Can't seem to find the fix to this. I sometimes have to completely put the car in park and shut off the car completely and usually it goes away and is fine for the remainder of the day but has acted up more often. I have ran codes on it and it said it was a sensor but was replaced and still acts up, fluid is full and no leak detected.
Mdutton81 is offline  
Old August-6th-2016, 03:45 PM
  #21  
Registered User
 
Marilyn Callan's Avatar
 
Join Date: Aug 2016
Posts: 3
Marilyn Callan is an unknown quantity at this point
The same thing happened to me this morning when I was out running errands. I have a 2010 Mazda3. I had Transmission fluid changed about 5000 miles ago and the vehicle had two other owners before me. Who knows what happened before I bought it. In fact, 6 months after I purchased vehicle from a large used car dealership that claims they recondition entire vehicle, I went to local quick oil change place for a routine change. I have a short commute to work, don't drive a lot and do work from home at times. They showed me the fluid and it was jet black. It should not have looked like that if it indeed had been reconditioned. So, I took it back to dealership and they changed it no charge to me. That was October 2014, I had it changed again earlier this year because, again, it was jet black. So that's 2 fluid changes in that many years. I called local Mazda service today and got an appointment for Tuesday.

Last edited by Marilyn Callan; August-6th-2016 at 03:51 PM.
Marilyn Callan is offline  
Old August-6th-2016, 03:52 PM
  #22  
Registered User
 
Marilyn Callan's Avatar
 
Join Date: Aug 2016
Posts: 3
Marilyn Callan is an unknown quantity at this point
Originally Posted by Mdutton81
Hello everyone,
I have an 04 Mazda 3, 2.3
Car has been very good until here recently. If I go to even start my car, AT light automatically comes on and says its in 4th gear. Can't seem to find the fix to this. I sometimes have to completely put the car in park and shut off the car completely and usually it goes away and is fine for the remainder of the day but has acted up more often. I have ran codes on it and it said it was a sensor but was replaced and still acts up, fluid is full and no leak detected.


Same thing happened to me today, I called and made an appointment for service.
Marilyn Callan is offline  
Old August-7th-2016, 11:54 PM
  #23  
Registered User
 
iXod's Avatar
 
Join Date: Aug 2016
Posts: 9
iXod is an unknown quantity at this point
Salespeople will tell you anything to sell you a car. The dealership will usually do a "detail" to the interior and the paint making it look as new as possible, and do *nothing* to the mechanicals. And then tell you they "reconditioned" the car.

You are miles ahead of the car-buying game if you simply tell yourself that everything the salesperson says is a lie. Sad but true for most of the trade.

Similar transmission problem here, this person eventually found it to be the transmission computer module (TCM):

https://www.mazda3club.com/mazda3-ma...problem-56278/

Good luck.
iXod is offline  
Old August-8th-2016, 12:05 AM
  #24  
Registered User
 
iXod's Avatar
 
Join Date: Aug 2016
Posts: 9
iXod is an unknown quantity at this point
Originally Posted by Marilyn Callan
...I had it changed again earlier this year because, again, it was jet black. So that's 2 fluid changes in that many years. I called local Mazda service today and got an appointment for Tuesday.
Did you look at the fluid after each time you had it changed?

In this car the AT fluid is not "changed". Only some of the fluid is drained; the remainder is un-drainable (it remains in the recesses of the transmission's inner workings). Rather, some (as much as is possible) is drained out and some new is added.

It is a fact that many transmissions -- including the Mazdas -- only drain out 1/3 to 1/2 of the total fluid when it is "changed". The rest of the old remains and mixes with the new fluid.

You can get your transmission "flushed" which does replace all the fluid, but not, typically, when it is "changed".

I hope this info will help you get more life from your Mazda.

Cheers.

Last edited by iXod; August-8th-2016 at 12:09 AM.
iXod is offline  
Old November-23rd-2016, 12:09 PM
  #25  
Registered User
 
mazguy's Avatar
 
Join Date: Nov 2016
Posts: 2
mazguy is an unknown quantity at this point
Check the last post here.
mazguy is offline  
Old February-25th-2022, 10:43 PM
  #26  
Registered User
 
Marsha's Avatar
 
Join Date: Feb 2022
Posts: 1
Marsha is an unknown quantity at this point
I have a 2010 Mazda 3 just bought it a couple days ago.

Originally Posted by Kendall_1208
Thank you ! I will def. try that..

My car is a Mazda 3, 4 door. 2006.
It ran great from sac to lake county then At light came on followed bye the check engine light, Now it's also jerks when the At light flash on.
when started moving wires under the hood and touch something and lights went off.???
No money done spent it on the car. Anyone have any ideas ??
Marsha is offline  
Old June-5th-2022, 08:45 PM
  #27  
njc
Registered User
 
njc's Avatar
 
Join Date: Jun 2022
Posts: 2
njc is an unknown quantity at this point
Originally Posted by Marsha
It ran great from sac to lake county then At light came on followed bye the check engine light, Now it's also jerks when the At light flash on.
when started moving wires under the hood and touch something and lights went off.???
No money done spent it on the car. Anyone have any ideas ??
According to my mechanic, those generations of cars are prone to TCM failures. We have a 2006 auto Mazda 3 with same problem - jerks into reverse, and Check engine and AT light on. Unfortunately, the TCM's are extremely expensive (we were quoted $1100 for a new module).
njc is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
David2006Mazda3
Mazda3/Mazdaspeed3
18
December-17th-2014 01:26 AM
MrCardinal
Mazda3/Mazdaspeed3
2
March-27th-2014 05:27 PM
joelhiers
Mazda3/Mazdaspeed3
1
May-21st-2012 03:57 PM
patel0516
Mazda3/Mazdaspeed3
10
May-23rd-2007 07:27 PM
hotprotege2002
3rd gen Engine/Drivetrain
40
April-10th-2003 04:50 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 


Quick Reply: engine light AND AT light



All times are GMT -5. The time now is 10:55 PM.