Mazda3Club.com : The Original Mazda3 Forum

Mazda3Club.com : The Original Mazda3 Forum (https://www.mazda3club.com/)
-   Exterior/Interior/Audio (https://www.mazda3club.com/exterior-interior-audio-4/)
-   -   help with firewall!!! (https://www.mazda3club.com/exterior-interior-audio-4/help-firewall-44828/)

Muccidawg June-3rd-2007 07:27 PM

help with firewall!!!
 
well i looked through the threads and ive seen a couple of people going through the glove box but there is no screws on the 07'! does anyone know the best place to go through with out having to drill a hole into the firewall! thanks!

jzoomer June-3rd-2007 08:50 PM

what are you trying to get in from the engine bay

Muccidawg June-4th-2007 12:47 AM

yea i dont want to run it through the door on the outside of the car, i got everything done except the power. lol. kind of frustrating i just wanted to see if anyone has it done on their 07.

Kidjai June-19th-2007 03:08 PM

I looked everywhere to see if there's a hole made already, but there isn't. I have a 04' so I'm not sure if it's the same procedure. If you look behind the battery terminal there is a circle rubber piece about 6inches down from the wall. Remove that and cut a whole. It's rubber so I melt it with my soldering kit. Put that back in and just stick the wire through. After that I ran the wire through the driver side floor panel. You can get to the rubber part by going underneath the driver side sort of behind the pedals. Water don't have access to it b/c of where it's located so You don't have to worry about it.

Sturg July-30th-2007 05:43 PM

When I installed aftermarket power locks on my 07' Mazda 3, I took out the glovebox and there's a rubber boot back against the firewall, it's held in by clips and that's where all the electronics went through the firewall.

djs2571 June-24th-2008 11:43 AM

I'm about to enlarge the hole used for the hood release cable to run my power wires through - saves a lot of wire and looks cleaner not to run the wires across the engine bay... i'm hoping it works out as cleanly as I expect.

djs2571 June-25th-2008 11:11 AM

A I was looking to make the hood release cable firewall hole larger, I noticed there's a white plastic plug behind the gas pedal which would support the older style gas pedal cable. This hole is large enough for a couple 6AWG wires I think, i'm going to expand it a bit for 4AWG wiring. Nonetheless it's a hole that's almost on the drivers side if you don't want to run wiring all the way across. It's also fairly well hidden behind / under the power brake booster diaphram.

Good luck

NCmazda3 October-19th-2008 09:16 PM

I got 2 AWG and 8 AWG through that hole with only a little filing. If you have an automatic, there's a big white plug in place of the clutch that works perfectly as well.


All times are GMT -5. The time now is 10:35 PM.


© 2024 MH Sub I, LLC dba Internet Brands