Mazda3Club.com : The Original Mazda3 Forum

Mazda3Club.com : The Original Mazda3 Forum (https://www.mazda3club.com/)
-   3rd gen Suspension/Brakes (https://www.mazda3club.com/3rd-gen-suspension-brakes-62/)
-   -   Loud Creeking Sound from Rear End (https://www.mazda3club.com/3rd-gen-suspension-brakes-62/loud-creeking-sound-rear-end-42728/)

BFKF95 July-17th-2006 10:15 AM

Loud Creeking Sound from Rear End
 
The noise occurs usually when I get started or when I come to a stop. When driving it seems to be quiet! My thoughts are link arm and bushings, but I am open to suggestions. Thanks!

BFKF95 July-17th-2006 10:19 AM

My apologies, I have a 99 Protege ES!

Da P-Funk! July-21st-2006 07:41 AM

Can you bounce the car/push the side/whatever to make the noise?

Try a shot of silicon spray at diffent points and test to see if that stops the noise - it will help isolate to the affected part.

Good luck and report back.

BFKF95 July-26th-2006 03:21 PM

I sprayed silicone on all the rear bushings and no help.

macdaddyslomo July-26th-2006 04:02 PM

rear sway bar bushings are probably shot

BFKF95 July-27th-2006 04:25 PM

Macdaddyslomo
r the rear sway bar bushings available separately? Is the rear sway bar the same as the Rear Stabilizer Bar?
Thanks for your help!!!

macdaddyslomo July-27th-2006 05:33 PM

YES AND YES...

check out anthony woodford racing(AWR)

BFKF95 August-2nd-2006 04:00 PM

I purchased the Sway Bar Bushings from the Dealer and took them to my neighborhood repair shop to have them installed. The creaking sound is no longer there. Thank you to macdaddyslomo and everyone else for their advice I appreciate it.

BFKF95 August-21st-2006 02:39 PM

The other day I heard the loud creaking sound again....... I think it's the Link Arm Bushings

macdaddyslomo August-21st-2006 03:48 PM

nope. it's your sway bar bushings again..it's a poor design by Mazda...there is a fix...look on msprotege for rear sway bar fix...

AWR offers it...that's why I forwarded you there...some urethane bushings will hold up longer too

mixmanmash September-6th-2006 04:10 PM

The creak on my car was from a worn stabilizer bar endlink. Go figure hey?


All times are GMT -5. The time now is 01:05 PM.


© 2024 MH Sub I, LLC dba Internet Brands