i just got my h and r's installed on my p5 and it looks tight, it makes a big difference...sean at automotive r and d installed them and he did a great job...the ride and the look is sick...just wanted to express my excitement!!!...i highly recommend getting lowering springs!!!

 

can you post some pics for potential buyers?

 

Yeah they are nice, except on my p5 the front sits just a tad higher than the rear. I finished my sub enlosure in the back, so I know how the back is sitting with the bumps in there. I'm fittin to pull my srpings out tomorrow and trim the front to level the car.

 

Hell yeah, I cut exactly 3/4 of a coil out on each spring in the front and it sits beatifully. The subs didn't really lower tha back thatmcuh, if any, but my car always sat higher in the front regardless. Now it looks all level and ****. What does your car look like Rawny? How many finger(s) can you fit in your wheel well in the front, and back of your car with the springs installed?

I'll try to post some before and after pics once I finish up this roll of film.

 

check out my pics:
http://www.cardomain.com/member_page...zda%20Protege5

 

Hmmm, yours look like its sits pretty good. Maybe I got some bunk springs or sumthin. But have you done the finger test yet? That's what I'm curious for, on level ground, would you stick a finger or two in your wheel wells for me. I just gots to know man, thanks.

 

sweeden,

its about one and a half finger gap, front and back...

 

Weird, cause when I put my H&R's on I could get two fingers easily in the front, and just over one finger in the back. Now with my subs in the back, and 3/4's of a coil in the front gone,I can get one finger in sideways in back, and can barely get one finger in flat wise in the front.