Where do I get a Fidanza Flywheel for my MP3, and how much will it cost?

 

http://www.aluminumflywheels.com/contact.html

Read here what it says under Retail Customers. That's probably your best bet on finding somewhere that carries it.

Hope this helps.

 

This is where I got mine. http://www.rr-racing.com/

 

Which Flywheel fits our 3rd gen 2.0's?

 

I got mine from RR Racing too... Rafi is a nice fellow

 

Since none cared to answer my question of which flywheel will fit, I am guessing that the one for 4 cylender, 2.0 will work? Am I right?

 

Mine isn't installed yet, and I'm not sure about the fit. The '93-'97 Probe/MX-6/626 used the G25M-R transaxle. The flywheel and clutch for that application is 225mm in diameter. I've heard the clutch for the F25M-R transaxle used in '95-'00 1.8L Proteges is 200mm with a smaller input shaft. I'm not certain about the G15M-R transaxle in the '01+ 2.0L Proteges or the F5M-R in the MP3. Greddy917, is yours installed yet? Did you get the flywheel and clutch?

 

I havent installed it yet...It is going on this Sunday...I did not get a new clutch...I am a cheap bastard and see nothing wrong with using the stocker untill it wears away...besides, it will take more than 55-shot Nitrous to seriously wear our stock clutch anyway.

Hopefully the install will be A-OK...if not, be prepared for some bad language

 

I just ordered mine! too bad it won't be shipped till after the 22nd. I wanted to get it put in with my engine.

 

I would have waited until Greddy917 gets his installed. That way you would know it fits. I'm kind of worried that the 225mm Fidanza flywheel and ClutchMasters clutch won't fit in the Proteges. So far, the information I've seen points toward the Protege having the 200mm flywheel and clutch.

 

Fidanza called me back today and they say it fits.