Mazda3Club.com : The Original Mazda3 Forum

Mazda3Club.com : The Original Mazda3 Forum (https://www.mazda3club.com/)
-   1st gen/323/GLC Engine and Drivetrain (https://www.mazda3club.com/1st-gen-323-glc-engine-drivetrain-59/)
-   -   car pulls hard but idles rough ???? (https://www.mazda3club.com/1st-gen-323-glc-engine-drivetrain-59/car-pulls-hard-but-idles-rough-22619/)

1ofdfew323 March-19th-2003 11:44 PM

car pulls hard but idles rough ????
 
well after i did my swap i replaced everything (major tune up) i did check the timing too and fix it. heres the problem. as i was dring to work about 7 miles down the freeway my car hesitated big time . everytime i step on the gas pedal the car will slow down so i down shifted and then i heard the enigne was stil on but when i stepped on the gas again it hesitated again and sounded like the engine turned off but it didn't.
i kinda figured i was running rich so i adjusted my spark plug gap from .041" to .042" and noticed that the plugs is black (carbon dep.) i had to advance my timing to 2degree so that i'll run a lil lean. now my car dont die on me but at idle ( the last line b4 the 1k rpm) its rought but not as rough as missfiring . does anyone know what the heck this is?????

demoninvictus March-20th-2003 04:04 AM

what grade of gas might you be using? a timing advance i thought was indicative of you actually using a higher octane fuel, and nothing less (91 octane in other words is what you should be using).
peace

1ofdfew323 March-20th-2003 12:59 PM


Originally posted by demoninvictus
what grade of gas might you be using? a timing advance i thought was indicative of you actually using a higher octane fuel, and nothing less (91 octane in other words is what you should be using).
peace

damn.....i never thought of that! b4 i did the swap i had full tank of 87 octane but then hold on.....even if the car is not advance its still rough on idle


All times are GMT -5. The time now is 07:06 AM.


© 2024 MH Sub I, LLC dba Internet Brands