ERL MF2...Fuel system
 

Info on MF2:
MF2 (Map Fueler - new version 2 ) about 320 dollars or less!
We at ERL believe everybody should know exactly what they are getting before passing over their hard-earned dollars; not merely a little piece of plastic concealing every bit of machine-code tailored to your car's ECU, unleashing all that hidden potential to achieve ultimate power. The MF2 is based on an open-architecture design, which means that the unit is freely re-programmable at any time, open to any one who possesses a small screwdriver: no computer interface is necessary! If this interests you, read on ... working alongside the original ECU, the MF2 controls its own set of injectors, four high-impedance injectors and two low-impedance injectors (not supplied). It is able to use the signal from the existing sensors, or it can operate independently. 3D-mapping is simple if a load- or pressure- signal is fed into the unit. We are not re-inventing the chip, but merely giving back the control to its rightful owner! More technical information will become available on this web page soon.
ADJUSTABLE PRESSURE SWITCH
This switch determines the point where the system starts to inject. It is normally fitted to the vacuum side of the inlet manifold (2D mode) for applications where load signal (throttle angle sensor) or manifold absolute pressure sensor (MAP sensor) is available, the pressure can be used in conjuction and enhance the 3-D mapping. The switch is of a 'normally-opened' type, adjustable pressure range 3-30psi (preset at 10psi from factory), 1/4T yields 3psi change.
HOOD
This Nitride rubber cap is for protecting the electrical contacts on both injector socket and pressure switch from the harsh environment of the engine bay
Standard BOSCH type fuel injector socket
The injector plug comes complete with mating pins and splash proof seal, which enables direct conection to a BOSCH type fuel injector.
10A fuse holder
A standard automotive inline fuse assembly, fitted with a 10A blade type fuselink.
Fuel injection loom (Red)
A high quality splash-proof plug, with seals, hosts nine UL and CSA approved wires for connection to the intended equipment/sensors. All mating pins of the socket/plug are gold-plated, all capable of carrying 5 amps of electrical current. An additional pair of wires supplies a stablised output voltage of 5 volts for driving a MAP (manifold absolute pressure) sensor.
HARDWARE
All mating inserts or connectors are tin-plated. Other fasteners are made with high quality 316(A4) stainless steel.
Mounting brackets
These mounting-brackets are made with 16SWG aluminium, power-coated to resist the toughest conditions; incidentally, the diecast case of MF2 is also coated with the same epoxy-based coating.
Instruction manual
A 20-page comprehensively-written instruction manual discusses every aspect of the MF2 in great detail, including over 20 schematic diagrams and illustrations.

I want about 250 obo for it.

racer456@yahoo.com

Josh