remote wire
 

i want to use something other than the hu for my amps remote wire, but i'm having trouble getting at my car lighter, any one have any suggestions or can you tell me how to get at my lighter? thanx

omg i have the same damn problem. I dont want the amp to start up with the HU, i was wondering is a switch can be installed? Something from RadioShack maybe?

i have solved my probs, my remote is switched with my fogs

yes you can.....but what you want to be careful about is....if you run the power from a source that doesn't go DEAD when the key is turned off.....and you FORGET to turn your amp off....you could find yourself in trouble......

and of course if you used a power source that goes off when you turn the key off....you don't have to worry about the switch anywah.

ahh, ok maybe i can figure out to switch of the amp on engine shutdown but have a switch to turn it on anyways. Cause i dont really want it to be on all the time. :)

Why the hell would you need to do this?
Do you only have a sub amp?
HOw can one respect themselves after listening to music without a sub or 4?:D

just run the switch off the power wire to the amps.
Also you can pick up a factory fog light switch for $30 and use that. I did this with my neons.

same here i dont wanna have it pumping all the time....headache!!! ahhhH!!!

check some of the older threads, there are some nice recipies for using a current sensing relay to turn on and off a sub amp.

I still like the 3 preout head unit the best here. Seperate volume adjust for the sub and you can kill it all together.

yeah my kenwood has a whole ass load of non fading options, but i want to access my lighter for the remote, i'm just not sure how to remove my center console to get at it

hmmm guess i dont have to worry about a switch for my remote. with my clarion i can just turn it off at my HU. and it will stay off until i tell it to come back one. just get EQ then ADJ then enter then arrow down to turn off.