HOW to: CEL/MIL FIX!
 

PLEASE MAKE THIS A STICKY or Locate to the How To!

I have seen lots of questions about how to make your own MIL/CEL Eliminator..This will work for any protege with 2.0L engine...Not sure on earlier models.

Well its really simple!

Tools Needed:
Wire Cutters
Soldering Iron
Solder
Electrical Tape
1-M Ohm Resistor ($1 at Radio Shack)
1-uF Capacitor($1 at Radio Shack)
Adjustable Wrench

Step1:
-Pop Open the Hood and get a look at the 2nd Oxygen Sensor
-There is a clip..Push the clip in and pull out the Male-Female Connection
-Using Adjustable Wrench Remove the Oxygen Sensor

Step2:
-Go somewhere you can use your Soldering Iron
-Cut the Blue Wire
-Remove the Sheathing on the White wire to expose the Copper Wiring Underneath
-Grab you 1m Ohm resistor and solder it into the bluewires you cut earlier
-Grap your 1uF capactiro and solder it into the wire that you unsheathed/exposed & than solder it on the connector side as show on the Pic!
-Grab your electrical tape and make sure you do a good job covering all the conections

Step3:
-Reinstall using the reverse directions in step 1!

Typical install time is 15-20min depending on your ability to solder!

Chas

http://www.msprotege.com/forum/attac...chmentid=10443

http://www.msprotege.com/forum/attac...chmentid=10435

P.S. Link to original Thread on Protege5.com

For those who didn't see in the other thread, I am an electical engineer and I soldered up a batch of these a few months ago. I have a few of these still left that I'm selling at $14/each shipped. They come with instructions and usually ship out the day of payment.

I accept paypal at bviele@harris.com

:nono: :thumbs do