Haltech?
I was wondering, I have a 1999 1.6 . Will the Haltech work on my car? and if so, what are the advantages? I dont know a hell of alot, im trying to learn.....Kaleb
|
How much is this?, where is it available? plzzzzzz!!..Kaleb
|
Originally posted by fatlanky How much is this?, where is it available? plzzzzzz!!..Kaleb http://www.barelylegaltransplants.com |
I was thinking about if this was possible. Have an o2 sensor in each exhaust runner that way you could tune every cylnder for perfect a/f ratio.
Or would this be a waste of time? |
Originally posted by FunkRider I was thinking about if this was possible. Have an o2 sensor in each exhaust runner that way you could tune every cylnder for perfect a/f ratio. Or would this be a waste of time? You would also have to use a Wideband o2 and not a normal o2 (narrowband). On a factory car, the cylinders are pretty close to the same since they are running batch fire, and some even multipoint. |
Hey Braden! I was wondering something. I was thinking of going with the Haltech when I go turbo but how hard is it to install it? What is involved when installing the Haltech (splicing wires, hard wire to the sensors, etc.). Also, how hard is it to tune? I do have some knowledge and know how but I just wanted to know if I can do everything in my garage. Thanks!
Dave |
Originally posted by PRO 5 But how hard is it to install it? What is involved when installing the Haltech (splicing wires, hard wire to the sensors, etc.). Also, how hard is it to tune? Tuning is not difficult at all if you can read bar graphs and have a general understanding of how engines work, what detonation is, and how to watch EGT and A/F Correctly. It's a very good learning experience. I just wanted to know if I can do everything in my garage. Thanks! |
Quick question that I just thought of a bit ago. Since our speedo/odemeter is tied into the ECU, what will happen when we go to a stand alone?! What do we need to keep the odometer working? I've been told that it all ties into the ECU but I hope that isn't completely correct or we'll have to figure out a way to run the speedo/odometer and the gauges with a stand alone.
|
Originally posted by Traveler What will happen when we go to a stand alone?! What do we need to keep the odometer working? If it is like this.....I would just install the haltech in parallel to maintain those extra functions. Then just pull the CEL from the back of the cluster. |
All times are GMT -5. The time now is 04:56 AM. |
© 2024 MH Sub I, LLC dba Internet Brands