Some general tech questions
 

Didn't know where else to post this.

What is rod ratio??
Is it the same as Bore/stroke ratio??
How is it determined?
Wich would be better for a normal street application vs. a performance application?

What is the diference between an open and closed deck block>??

I had a few others, but I'll be damned if I can think of them right now.

Clipped from HS Tuners...
*************snip*************
What is R/S?
R/S is the abbreviation for rod to stroke ratio. It is the ratio of the length of the connecting rod to the length of the piston stroke, or the distance the piston travels from the top to the bottom of its stroke. As the ratio gets lower, the amount of stress on engine internals increases exponentially, killing long-term reliability. The higher the number is, the slower the piston is traveling, killing power output.

The ideal R/S is 1.75:1 (Three cheers for the B16A, at a near-perfect 1.74:1!).

Why a low R/S is bad for reliability...
A low R/S means the rod will be closer to a horizontal angle on its upstroke. This means that more of its force will be pushing the piston horizontally, rather than vertically. What does this mean for your engine? Two things.

1. There will be more stress on the sides and in the center of the rod, rather than on its ends, leaving the rod more vulnerable to breaking. Picture a straw. This is no special straw, just an ordinary drinking straw. Is it going to be easier to bend this straw by applying pressure onto its ends, or at its center? Now think of your poor connecting rods..

2. There will be more stress on your cylinder walls. Once again, the rod is pushing the piston at a more horizontal angle- right into your cylinder walls, rather than up and through them. The risk here is double: A. Putting that piston right through the cylinder wall. B. The cylinder wall will actually flex under the pressure, causing the shape to turn from a circle to an oval or oblong shape. This causes the loss of the seal created by the piston rings. What happens? A small amount of oil could slip past into the combustion chamber. Bad things happen from here: The oil gets combusted, leaving nasty carbon deposits in your combustion chamber and exhaust ports- not a good thing for flow or valve sealing.

It's also important to note that as the RPMs increase, so does the amount of stress on your engine's internals.

*************snip*************


Google is your friend.