Mazda3Club.com : The Original Mazda3 Forum

Mazda3Club.com : The Original Mazda3 Forum (https://www.mazda3club.com/)
-   2nd gen Engine/Drivetrain (https://www.mazda3club.com/2nd-gen-engine-drivetrain-58/)
-   -   Manual Transaxle Fluid Change (https://www.mazda3club.com/2nd-gen-engine-drivetrain-58/manual-transaxle-fluid-change-26522/)

mrmalecky June-2nd-2003 01:28 PM

Manual Transaxle Fluid Change
 
I'm coming up on 60K, and would like to change my transaxle fluid. While doing an oil change this weekend, I noticed the nice, big, convenient drain plug -- it looks like about a 1" socket will work. My problem is, where do you put fluid in? I couldn't find any bolts on the top of the transaxle that seemed like they would work.

98 LX 5spd

kansei June-2nd-2003 03:01 PM

Same size plug on front of transmission is for filling.

protegeboy78 June-2nd-2003 04:07 PM

i thought there was somewhere in the engine you had to do that.... the manual i have says someting about a speedometer wire or something you have to remove and poor it in there

Bruce95fmla June-2nd-2003 04:56 PM

you really don't have to change the fluid in there .. it's supposedly sealed for life
Bruce

kansei June-2nd-2003 06:19 PM

1st gen had the speedo gear fill .

nowkeg June-2nd-2003 11:50 PM

there is a big bolt in the middle of the tranny. the bottom bolt is the drain. it's a messy, slimy, stinky job... but it does shift smoother. i did mine when i bought it. it had about 120k miles. no one i know does the job but i say why not? it ain't expencive and hey it's fresh fluid. no speedo cable removal nessisary if i remember correctly.

pollito14 June-15th-2003 07:40 PM

When I checked my tranny fluid I had to remove the battery, battery tray and look under the intake area towards the firewall. You will see a cable going into the tranny take that off and with a 10mm I think you undo the plug and check the level. I don't know if you can fill there.

My conclusion of tranny oil level was inconclusive therefore I don't know if I have oil/grease in my tranny. Ain't that nice?

UCSBgeek June-15th-2003 10:38 PM

don't use a 1" socket, look to see if it is 19mm or 24mm, maybe. Use a metric 6 point socket!!

kansei June-16th-2003 02:49 PM

its a 23 mm for the fill and either a 23 or some had 24 mm for the drain. Don't remove the smaller bolts next to the fill hole they are for the shift forks and reverse idler shaft.

protegeboy78 June-16th-2003 10:26 PM

is a manual transaxal fluid change the same as a manual transmission change just a different name for it? cause it almost sounds like two different things but both are being discussed

UCSBgeek June-16th-2003 11:14 PM


Originally posted by protegeboy78
is a manual transaxal fluid change the same as a manual transmission change just a different name for it? cause it almost sounds like two different things but both are being discussed
Yeah, it's the same thing--technically the car has a transaxle, as it is front-wheel-drive, but most people call it transmission anyway.

protegeboy78 June-16th-2003 11:18 PM

thanks for clarifying... i had no idea about that... still learning

UCSBgeek June-16th-2003 11:22 PM


Originally posted by protegeboy78
thanks for clarifying... i had no idea about that... still learning
No worries, still learning stuff everyday myself ;)

Samus June-17th-2003 04:25 AM

i haven't changed the fluid on my protege with 88k myself. last manual trans i change fluid on was my old pos 90 accord. if anyone's ever driven one of these, u know how crapy the shifter is linked to the trans (with a cable, not a rod...) so it was hard to notice any difference in shift quality as it continued to shift like shit :)

i might change mine this summer, but i was always told, if you don't change your fluid on time, don't change it at all, ever... but i think that applies to automatics only.

weimerrj June-27th-2003 12:41 PM

Manual Tranny Fluid Refill
 
I've a '95 ES with 1.8, and the tranny drain was located on the bottom, 23 millimeter, as I recall. The fill was about 8-10 inches away, and on the drivers side of the transmission facing forward. Real easy to get at with a wrench. the bolts held pretty hard, but broke away abrubtly. Be careful, I cut my finger when the wrench moved suddenly. Both the drain and the fill are the same size and look alike. I'd recommend cracking the fill before the drain in order to let the fluid (75W-90) drain more easily.

Filling is a little difficult, but I have a funnel with a short (2 foot) piece of plastic tubing attached(old beer bong!), made the job a lot easier, just snake the tube down by the battery and stick it in the fill hole. The transmission takes 2.8 quarts, when it starts to come out the fill hole, you're done. Just tighten back up and drive off.


I just did this last weekend, only took about a half hour.


All times are GMT -5. The time now is 08:56 AM.


© 2024 MH Sub I, LLC dba Internet Brands