Mazda3Club.com : The Original Mazda3 Forum

Mazda3Club.com : The Original Mazda3 Forum (https://www.mazda3club.com/)
-   1st Gen Protege/323/GLC (https://www.mazda3club.com/1st-gen-protege-323-glc-38/)
-   -   car cranks but doesnt start ? (https://www.mazda3club.com/1st-gen-protege-323-glc-38/car-cranks-but-doesnt-start-31208/)

Abzzz September-15th-2003 09:30 PM

car cranks but doesnt start ?
 
ok as usual 2day morning.. i try starting car... it just cranks.. wont start.. checked battery all fine.... is it the starter ?

Abzzz September-15th-2003 09:39 PM

cranks as in it turns over .. just doesnt start ....

Boston September-15th-2003 11:10 PM

If the cranking sounds normal, then it's not the starter.

Could be a broken rotor, distributor cap, wire, plugs. Something with the ignition. Could also be a faulty fuel, oxygen, or other sensor.

midnightblue97 September-16th-2003 04:58 PM

You got fuel?? I know it sounds stupid, but it happens.
Your timing belt could have some stripped teeth, not likely but I've seen that happen before.

macklum September-16th-2003 06:20 PM

Check inside distributor cap for mosture ,also make sure the plug on the VAF is plugged in .Check fuel pump fuse .Check fuel cap is on tight . These are a few that have happened to me when I owned my 92 DX

Abzzz September-16th-2003 08:58 PM

distributor cap was gone.. Thanx ppl!

macklum September-17th-2003 03:54 AM

What gone as in missing or gone as in the contacts were done or a crack the distributor .

Abzzz September-17th-2003 04:01 AM

the contacts

TaiMaiShu September-19th-2003 10:12 PM


Originally posted by macklum
What gone as in missing or gone as in the contacts were done or a crack the distributor .
lol. missing. where would it go?


All times are GMT -5. The time now is 03:13 AM.


© 2024 MH Sub I, LLC dba Internet Brands