air flow & pressure sensor wire
 

Hey guys , I am wondering if anyone here knows what wire on the ecu harness (bp10 ecu) is for the air flow sensor.I have the haynes manual but it is not clear or the diagram is a little different for some reason or the other I cant seem to find the right wire, all others are just fine.
I am installing a super afcII on my jdm bp05 and was also wondering if anyone can share what settings work well with n/a setup with minor mods( intake, exhaust, advanced timing,fuel pressure regulator)
I checked the faqs and wasn't able to find anything.
Any info greatly appreciated.

wire?
 

I suspect the red wire is the one you want. This based on viewing
page 12-25 of my Haynes Manual. The air flow moves a small vane
attached to a potentiometer [A three-terminal resistor with an adjustable center
connection, widely used for volume controls]. This resistance value is sent back to
the ECU. The B/LG (black/light green)wire is simply a sheild and is not directly connected.

To confirm this try going to www1.autozone.com to view a schematic for your car.
You need to register, but it's free.

Good Luck