Mazda3Club.com : The Original Mazda3 Forum

Mazda3Club.com : The Original Mazda3 Forum (https://www.mazda3club.com/)
-   1st gen/323/GLC Engine and Drivetrain (https://www.mazda3club.com/1st-gen-323-glc-engine-drivetrain-59/)
-   -   Car won't start!!! (https://www.mazda3club.com/1st-gen-323-glc-engine-drivetrain-59/car-wont-start-16425/)

Funky Buddha November-19th-2002 06:14 PM

Car won't start!!!
 
I took my car in to the dealer to get an engine clean(shampoo) and now it won't start. They say it's been narrowed down to the distributor. They've even gone as far as putting a test one in. It works for a couple of min. then it dies again and it won't start after that.

Any suggestions?

Funky Buddha November-21st-2002 12:15 PM

Looked through it and there was nothing. The shop said I'm gonna have to get a new distributor. Any other ideas? I mean, this car's never had a stalling history, the thing worked when i drove it to the shop and they drove it into the garage.

jeremy November-27th-2002 02:45 PM

if its at a shop.....and you know trust the mechanic ..go with what he says...



my advice would be to get a new cap....make sure all the spark plug wires are plugged in all the way as they may have been knocked around while cleaning...


after that ..i don't know....i believe though that if you take the distibutor cap off and the rotor button...there is a small plate wich connects the wires in the distributor that will cause the car to turn..but not turn over....

but I WOULD GO WITH WHAT THE SHOP SAYS...

ALL THESE PARTS I MENTIONED CAN BE BOUGHT @ AUTOZONE OR WHJATEVER FOR LIKE 3-6 DOLLARS A PIECE.....

later

obeytheflag December-1st-2002 09:45 PM

just a suggesting...you think anything might be wrong with the air flow meter? check that too cuz i had a problem (when installing intake) and the car would not start. hope its nothing major for you

Funky Buddha December-2nd-2002 01:00 AM

Well..it was the distributor...the shop paid for half. Works fine now..thx guys

snart December-8th-2002 11:45 AM

this happened to my PGT after I washed it and I eventually (after replacing the damn starter and other various things:mad: ) narrowed it down to the battery not having a good connection. So I went and got some of that red goop and put it on the terminals and brushed them, that took care of it.


All times are GMT -5. The time now is 06:39 PM.


© 2024 MH Sub I, LLC dba Internet Brands