question about sport exhaust from dealer
#1
question about sport exhaust from dealer
has anyone here bought a sport exhaust from the dealer? is so how much did you pay ($220.00 u.s. here)? how hard was it to install? and how does it sound?
#3
$195 to $200 is the going price at every dealer....
its a snap to install...there are only two bolts and the two hanger rods
its a bit louder than stock...but not a lot.....
its a snap to install...there are only two bolts and the two hanger rods
its a bit louder than stock...but not a lot.....
#4
I have one. I like it. I had went through 3 different mufflers trinng to find one that sounded good. I bought mine from the Dealer for 189.00 us. if you want go to mazdastuff.com and they have it. Make sure you get the one for the p5.
#7
i ahve had one since the past summer and i love it. and the fact being it is a bosal exhaust if u get the mazdaspeed axle back and it is a factory bolt on no work needs to be done.
arul
jsut my 2 cents
arul
jsut my 2 cents
#8
gcs118 is right. I love my Mazdaspeed exhaust.
Here's a pic:
If I was to do it over again, I'd consider a Racing Beat cat-back, but thr RB is like twice as much $, and the Mazdaspeed sounds mighty sweet.
Here's a pic:
If I was to do it over again, I'd consider a Racing Beat cat-back, but thr RB is like twice as much $, and the Mazdaspeed sounds mighty sweet.
#10
Originally posted by pingdum
Hey irish6714, I notice that you had a custom set up made to go with your Mazdaspeed exhaust. What size pipe did you use. Did you get any power gains? Did you just junk the resonator?
Hey irish6714, I notice that you had a custom set up made to go with your Mazdaspeed exhaust. What size pipe did you use. Did you get any power gains? Did you just junk the resonator?
also the part number is 0000-8m-c10
Last edited by irish6714; March-17th-2003 at 07:06 PM.
#11
got the mazdaspeed axel back today and did the install!!!! my wife had called a muffler shop while i was out picking up the parts and they quoted her $60 for the install. it was so simple 2 14mm bolts 2 hangars, and about 15 min of work (no cussing and no blody knuckles). by the way it sounds sweet. not too loud at idle but a nice deep tone above 3000rpm. thanks for the help and advise. now the next question where can i get a mid pipe to go with it??
Thread
Thread Starter
Forum
Replies
Last Post
alxmaverick
Mazda3/Mazdaspeed3
7
September-20th-2009 08:04 PM
kenchan
3rd Gen Protege/MazdaSpeed/P5/MP3
16
March-28th-2003 07:31 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)