Mikeyb

I subscribe to Grassroots Motorsports and in the latest issue it has an article about Flyinmiata's new Protege 2.0 Stage1 Turbo kit. The kit boost hp from 96whp to 149 whp and 108lb-ft to 173lb-ft of torque. The also said if a 2.25 inch cat-back exhaust is added the numbers would go to 167whp and with 191lb-ft of torque. The kit goes for $3595. The article also stated that the kit would work on a 1.8l with some plumbing mods done to the car. Flyinmiata plans to have 1.8l turbo kit also available in the near future. Here's the website:

http://www.flyinmiata.com/protege/

I was wondering if anyone has this kit on their Protege?

Joel

I also herd from fm the turbo sounds good if you have other mods the hp will be higher.
joel

2002 protege dx
AEM intake
unorthodox crank pulley
eibach sport spring
borla cat-back
twm sort throw shifter
act clutch
9 pound flyweel
front strut tower brace
mazda speed intake and exhaust cams (added 25hp) 400.00

airedoutmp5

that is the kit that starts a 6lbs of boost right? how much more can u turn the boost up to? im lookin to turbo my mp5 please let me know somebody please

Joel

I herd of some cars running 8psi the tranny on the protege cant handle more then that. I also herd are engine can handle up to
12 psi stock all you need to do is get a better tranny.

Im also saveing for the fm turbo get going to upgrade to the other
B.O.V

IM going to kill the civic

RAAZ227

There are A LOT of turbo kits out there for the FS-DE. Here is a couple:

Spool ITS
FM kit
HiBoost
Wagner Motor Sports.

www.spool-turbo.com

www.hiboost.com

Fm you already know the lin

www.wagnermotorsports.net

Check them out! They all have a lot of good kits to offer!

goprobego

Does anyone know if these kits will work on the ford probe's 2.0L?

RAAZ227

Not sure... I think the manifold will probablly fit. But you would have to mod all the plumbing.

vivid03mp5

i coulda swore i read somewheres that hiboost was runnin on 12 psi all stock... but i donno. i think there was a new clutch but i think that was it. i just need to borrow $4000 from someone.

paulmp3

They run 12psi at the track, i think on 92 octane also.

goprobego

All turbo'ed cars need to run 92 or higher octane.

dficken

You can run higher boost than 6psi but not with the FMU (at least its not recommended. It basically dumps fuel and I have heard it doesn;t work that great above 6 or 7 psi. You need a piggy back unit or something similar to manage the air/fuel ratio (amongst other things) with precision at higher boost levels. Supposedly the stock internals are good for 225 whp (the rods actually).

paulmp3

i was just saying that 92 oct. is low for 12psi and track use.

vivid03mp5

as far as forged pistons go. are there any out there for the mp5 that arnt high compression?

goprobego

oh, my bad

markmurray77

I believe Je and Pauter make forged internals for the 2.0L